Canon VK-16 Setting Manual page 86

Configure Motion and Sensor Settings
●
Step 2: Set the active region for recording
●
Step 3: Set Motion Detection Options
Set the following options on the Motion Detection Setting dialog.
If you select the Camera Sever to detect motion, Settings... becomes available. Click to
launch your VB Admin Motion Detection Setting Tool. You must have VB Admin Tools
installed in advance. Refer to the Camera Server's User's Manual for how to configure the
motion detection settings. Refer to the Administrator's Manual for important information on
Camera Server-based motion detection.
Note
86
In the Active Region field, adjust the region where
motion detection is triggered. By default, the Active
Region is the full area. You cannot use pan, tilt,
and zoom operations in this window.
● To use the motion detection function of the VB-C50i/VB-C50iR,
VB-C50FSi and VB-C50Fi, it is necessary to configure schedules
from the "VB Admin Schedule Setting Tool".
● Setting motion detection at the Storage Server causes high
CPU load. It is strongly recommended to set motion detection
at the Camera Server whenever it has the motion detection
function.
Click one of the corner or edge handles and
1
hold down the mouse button.
Drag the handle to change the motion-trigger
2
boundary (dotted frame); click the corners to
adjust the area or click the edge handles to
bring each side in or out respectively.
In the Detect Motion Using menu, select
1
one of the following:
Storage Server
Obtains video from the Camera Server and
detects motion with the Storage Server.
Camera Server
Uses the Motion Detection function of the
Camera Server to detect motion (This menu
is only active for VB150 servers with the
Video Input set to Single or VB-C50i/VB-
C50iR, VB-C50FSi, VB-C50Fi).
In the Analysis Frame Rate menu, select
2
from 0.1 to 30 frames per second.