Using the Add Camera Server Dialog
Tip
●
Step 3: Select the Storage Server for recording
Note
●
Step 4: Configure External Device Input
64
If you have a Multi-Terminal Module VB-EX50 unit plugged into a
VB-C50i/VB-C50iR/VB-C50FSi/VB-C50Fi and have configured the
"Use External Video Input", video seen in the Viewer may be
taken from cameras connected to the Multi-Terminal Module.
Switch the video at the Admin Viewer as required.
● Recording schedules must be set in order to record video.
Refer to Chapter 6 for how to set recording schedules.
● There is a maximum number of 64 Camera Servers that can be
registered on one Storage Server with VK-64 (or 16 cameras
with Network Video Recorder VK-16).
● If you have changed the Camera Server's IP address, you also
need to change the host names in the Connection Settings
and Storage Server Settings dialogs.
Select a Storage Server from the
1
drop-down menu which lists pre-
configured Storage Servers and
enter the Host Name or IP address
in Host Name or IP and Port
number in Port.
If you do not want the Camera
2
Server to be recorded video,
select Do not record from the
drop-down menu of Storage
Server.
To switch On or Off the external device
input, tick the Invert the state of the
following external option.
* One or more inputs may show depending on the
type of the Camera Server. It is not necessary to
change this setting if it is not required.