Add A Camera Server - Set Connection Details - Canon VK-16 Setting Manual

Add a Camera Server - Set connection details

To add a Camera Server, you must specify how VK-64/VK-16 can connect to the camera
server as follows:
●
Step 1: Enter Host Name, User Name and Password
This is the User Name and Password configured on the Camera
Server side, not your VK-64/VK-16. If you do not know your
Note
Camera Server user name and password, ask your System
Administrator.
●
Step 2: Click Connect
Click Connect when you have added the above information.
Once the Viewer has connected with the Camera Server, a tab is shown next to the Add
Camera Server dialog.
● You must click Connect before clicking OK to close the dialog
(the OK button is disabled until you do so).
Note
● When two or more cameras are used with VB150 (when "Video
Input" is set to "Single"), two through four tabs are added. The
number of tabs shown for a VB150 does not indicate the
physical number of cameras connected. It indicates the
number of cameras which have been enabled using the VB150
Camera and Video Settings Page. Please refer to Chapter 3,
P. 36 of the VB150 User's Manual for more details.
● If "Video Input" is set to "Single" for VB150, the camera name
displayed as the Camera Server Name is the first camera name in
the server's camera name list when "Use Camera" is selected on
the Camera and Video Settings Page. Therefore, it is recommended
that the Administrator should set the first camera name to be a
general name, applicable to the entire Camera Server.
● If you are using a VB150 with the "Settings Web page URL" other
than the default setting "admin", a connection error occurs when
you click Connect. Restore the default setting and try again.
Using the Add Camera Server Dialog
Enter the Host Name or IP address
1
in Host Name or IP, then enter
the port number for the Camera
Server in Port.
Enter the user name in User Name
2
and password in Password to
connect the Camera Server. The
settings are then saved to the
Storage Server.
5
63