GE VAT2000 Instruction Manual page 73

5-9-6 Torque ratio 2, torque bias 2 setting
(1) Torque ratio 2 setting selection
The following two types of torque ratio 2 setting inputs can be used.
One of the two types of inputs can be selected by setting a parameter or with the sequence input.
Setting
input point
Serial IO link II torque ratio 2
setting
Panel Panel torque ratio 2
setting
(2) Torque ratio 2 setting selection sequence
The relation of the torque ratio 2 setting and changeover sequence is as shown below.
S e ria l To rqu e ratio 2
O . P an el Torq ue ra tio 2
settin g (B 13 -3 )
IS B II torqu e se tting
5. Control Input / Output
Setting data
This is a setting value issued from the host computer with
serial transmission. An IO link II serial interface option
(type: U2KV23SL2) is required.
This is a setting value issued from the parameter (B13-3).
XX X
XX X
O ptio n
M o u n ted
o n
0
N o t m o u nte d
o ff
Fig. 5-15 Torque ratio 2 setting selection
Explanation
Fu nction s that can b e co ntrolled O N / OF F
:
from terminal board
Fu nction s that can b e co ntrolled O N / OF F
:
By parameter settin g only
C 0 2-5
=1
=2
C FS
o ff
L C L
=3
o n
0
5-20
Torq ue ra tio 2
settin g
o n
TR Q B 2
Torq ue b ia s 2
settin g
o ff