GE VAT2000 Instruction Manual page 38

(Continued from previous page)
Block-C Parameter Mode
knob
or
key
Utility mode U
(Note) At the default setting, only the basic functions are displayed, but the extended function, software
option function, hardware option function parameters are skipped.
Thus, to display these parameters, change parameter A05-0 to 3 (parameter B, C block skip
setting), so that the target parameters are displayed.
4. Operation Panel (Keypad)
: Parameters changed infrequently during the normal usage
Basic function settings
Control Methods
Start/stop frequency
Various setting input selection
Sequence input terminal function -1
Sequence input terminal function -2
Sequence input terminal function -3
Analog input terminal function
Automatic start setting
Parameter Protection/Operation Locks
Custom parameter register
Operation panel mode setting
Setting input terminal function
Output terminal function
Meter output gain
Status output detection level
Extended function setting
Start Interlock
Retry/pick-up
Overload
Start/Stop frequency overload (dual drive)
High efficiency operation
Standard serial communications
Hardware option function setting
Control mode selection
Main circuit option selection
PC Parallel interface option
Sequence output terminal option
Serial interface option
: for future use
Fig. 4-2 (3) Parameter configuration
4-5
(C00-0~7)
(C01-0~1)
(C02-0~1)
(C03-0~8)
(C04-0~9)
(C05-0~7)
(C07-0~5)
(C08-0 )
(C09-0~4,6,7)
(C10-0~7)
(C11-0,1,3)
(C12-0~4)
(C13-0~5)
(C14-0~1)
(C15-0~4)
(C20-0~3)
(C21-0~3)
(C22-0~2, 4)
(C23-0~4)
(C25-0~1)
(C26-0~2)
(C30-0)
(C31-0~1)
(C32-0~2)
(C33-0~1)
(C34-0~5)