Reading The Changed Parameters (Non-Default Value Parameter List) - GE VAT2000 Instruction Manual

4-6 Reading the changed parameters (Non-default value parameter list)

1) The Monitor Parameter d20-2 is the entry into the Block-A, B and C Non-Default Value Parameter
Listing Mode.
2) In this Non-Default Value Parameter Listing Mode, the display will show the Block-A, B and C
Parameters that have different values from their default values. These Parameter values can also be
read and changed in this mode.
3) The below shown example is valid if the V/f control (constant torque) is enabled, (C30-0=1). This is
an example for reading C14-0 (FM output gain) and changing its value.
Keys
(1)
(2)
(3)
(4)
6 times
(5)
(6)
(7)
(8)
(9)
(Continued on next page)
4. Operation Panel (Keypad)
Display
↓
↓ ↑
↓ ↑
↓ ↑
4-16
Explanation
(In Block-B Parameter Setting Mode)
Change to Block-C Parameter Setting Mode.
Change to the Utility Mode (For future use)
Change to the Monitor Mode.
Increase the Parameter Block Number from d00 to
d20. Increase the parameter number.
Go to d20-2 (Non-Default Value Parameter List Mode
Entry).
After one second, [LST] will display. Enter the Non-
Default Value Parameter List Mode.
The display will alternate between the Parameter
No. of the parameter (A03-1) changed first from the
default value and the present setting value.
The next Non-default Value Parameter Number will
display. If is turned, the next Non-Default
Value Parameter Number will increment or
decrement and display.
The Parameter C14-0 (FM Output Gain) will display.
Select parameter C14-0.
The setting value change state will be entered.