GE VAT2000 Instruction Manual page 41

(Continued from previous page)
Block-C Parameter Mode
knob
or
key
Utility mode U
(Note) At the default setting, only the basic functions are displayed. The extended function, software
option function, hardware option function parameters are skipped.
Thus, to change these parameters, change parameter A05-0 to 3 (parameter B, C block skip
setting), so that the target parameters are displayed.
4. Operation Panel (Keypad)
: Parameters changed infrequently during the normal usage
Basic function settings
Control method
Various setting input selection
Sequence input terminal function -1
Sequence input terminal function -2
Sequence input terminal function -3
Sequence input terminal function -4
Analog input terminal function
Automatic start setting
Parameter protection/Operation Locks
Custom parameter register
Operation panel mode setting
Setting input terminal function
Output terminal function
Meter output gain
Status output detection level
Extend function settings
Start interlock
Retry/pick-up
Load setting
Start/stop frequency overload (dual drive)
Speed detection error monitor
High efficiency operation
Standard serial communications
Hardware option function settings
Control mode selection
Main circuit option selection
PC Parallel interface option
Sequence output terminal option
Serial interface option
Encoder setting
: for future use
Fig. 4-3 (3) Parameter configuration
4-8
(C00-0~7)
(C02-0~8)
(C03-0~8)
(C04-0~9)
(C05-0~9)
(C06-0~8)
(C07-0~9)
(C08-0)
(C09-0~7)
(C10-0~7)
(C11-0,1,3)
(C12-0~4)
(C13-0~5)
(C14-0~1)
(C15-0~4)
(C20-0~3)
(C21-0~3)
(C22-0~2,4)
(C23-0~4)
(C24-0~3)
(C25-0~1)
(C26-0~2)
(C30-0)
(C31-0~1)
(C32-0~2)
(C33-0~1)
(C34-0~5)
(C50-0~2)