GE VAT2000 Instruction Manual page 52

4) The following is an example for changing the value of a Custom Parameter.
Keys
Register parameter B10-0 on Parameter C10-0 (Custom Setting).
(1)
(2)
(3)
(4)
(5)
(6)
Change parameter B10-0 which has been assigned to A04-0.
(7)
3 times
(8)
(9)
(10)
(11)
Note 1) If the Parameters C10-n values are either 1.99.9 or any other undefined values, Parameters
A04-n will be skipped during Parameter scan.
Note 2) If all the C10 Parameters are set at 1.99.9. all the A04 Parameter block will be skipped during
Parameter scan.
4. Operation Panel (Keypad)
Display
↓ ↑
↓ ↑
↓ ↑
↓ ↑
4-19
Explanation
(Mode and Parameter Number Change to C10-0)
The display shows Parameter C10-0.
The value 1.99.9 indicates that no Parameter has
been registered on Parameter C10-0.
Select Parameter Number C10-0.
Set the sub-number of B10-0 to "0".
Each time is pressed, the flickering digit will
move to the digit to be changed.
Turn the knob key until the high-order digit
reaches the block No. 10.
Selection of the parameter No. C10-0 is completed.
Note) For parameter C, set as 2.xx.x.
Enter the Block-A Parameter Setting Mode.
The Custom Parameter Number A04-0 will display.
The display will alternate between Parameter
number A04-0 and the value of Parameter number
B10-0 (Acceleration time 2).
Parameter Number A04-0 is the same value as that
of Parameter Number B10-0.
Parameter B10-0 can be changed now from
parameter A04-0.
Change the value as required.
Store the new value.