GE VAT2000 Instruction Manual page 48

Keys
Change the parameter A03-1 (DC Breaking Time) from 2.0 (default value) to 3.5.
(8)
(9)
(10)
(11)
(12)
3 times
(Note 1)
(13)
(14)
(Note 2)
(15)
(16)
(17)
2 times
(18)
(19)
(Note 1) When the Block Number is changed by
or down according to
(Note 2) If (RUN) displays while the parameter is being set in (4) and (14), the parameter is one of
those that can only be changed while the inverter is stopped. In this case, stop the motor first,
and then press
4. Operation Panel (Keypad)
Display
↓ ↑
↓ ↑
, turned immediately before.
again.
4-15
Explanation
(In Block-B Parameter Setting Mode)
Changes to the Block-C Parameter Setting Mode.
Changes to the Utility Mode. (For future use)
Changes to the Monitor Mode.
Changes to the Block-A Parameter Setting Mode.
Increase the Parameter Block Number from A00 to
A03.
The display will alternate between Parameter
Number A03-1 and the present value 2.0.
Enable the value to be changed.
The preset setting value will display.
Press once to move the flicker to the digit that
is to be changed.
Change the flicker digit from 2 to 3.
Move the flickering digit to the digit to be changed
Change the flicker digit from 0 to 5.
Fix the data.
Changing of parameter A03-1 to 3.5 will be
completed.
The display will alternate between the Parameter
Number A03-1 and the present value.
(Parameter Number Changing Mode.)
, it will change to the next Block Number either up