Eaton EMR-4000 Installation, Operation And Maintenance Manual page 741

Technologies ® optical fiber products. In addition, these same distributors offer long rolls of cable with connectors that
can be installed in the field. Some distributors will make custom lengths to order.
The fiber termination at the URTDII simply snaps into or out of the connector. To connect the fiber termination at the
protective device, push the plug of the fiber optic onto the device interface then turn it until it "snaps".
Force is 11 pounds (50 Newtons).
Surplus length of a pre-cut fiber does not cause a problems. Simply coil
and tie the excess fiber at a convenient point. Avoid high tie pressure.
Bending radius of the fiber should be greater than 2 in. (50.8 mm).
The protective device as well as the URTDII have various power supply
options. Make certain that the power supply is acceptable for both units before
connecting the same power supply to both devices.
EMR-4000
www.eaton.com
IM02602009E
741