Eaton EMR-4000 Installation, Operation And Maintenance Manual page 28

EMR-4000 IM02602009E
DO NOT over-tighten the mounting nuts of the relay
(0.164 X32 ). Check the torque by means of a torque wrench (1.7 Nm [15 In-
lb]). Over-tightening the mounting nuts could cause personal injury or damage
the relay.
Outline Standard Mount - Door Cut-out
The housing must be carefully grounded. Connect a ground cable (AWG
2
12-10 [4 to 6 mm ] / 15 In-lb [1.7 Nm]) to the housing, using the screw that
is marked with the ground symbol (at the rear side of the device).
The power supply card needs a separate ground connection (AWG 14
2
[2.5 mm ] / 5-7 In-lb [0.56-0.79 Nm]) at terminal X1.
www.eaton.com 28