Driven Pulley Face Bearing Replacement - KYMCO SUPER 9 50 Service Manual

7
. KICK STARTER/DRIVE PULLEY/
CLUTCH/DRIVEN PULLEY
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Check the needle bearings in the driven
face and replace them if they have
excessive play, damage or abnormal noise.
Drive the inner bearing out of the driven
pulley face.
Remove the drive outer bearing out of the
driven face.
Drive a new outer bearing into the driven
face with the sealed end facing up.
Seat the snap ring in its groove.
＊
Pack all bearing cavities with 5.0～5.6g
grease.
Specified grease: 230℃Heat-resistant
grease
SUPER 9
Inner Bearing
Bearing Outer Driver
50
Outer Bearing
7-14