Cylinder Head Removal - KYMCO SUPER 9 50 Service Manual

6
. CYLINDER HEAD/CYLINDER/PISTON
CYLINDER HEAD
REMOVAL 〈SH10AD〉
Remove the rear carrier.
Remove the frame body cover. ( 2-2)
Drain the coolant.
Disconnect the thermosensor wire from the
thermosensor.
Disconnect the water hose from the
thermostat housing.
Remove the spark plug cap.
Remove the two joint lock nuts on the front
of the exhaust muffler and then remove the
two exhaust muffler lock bolts.
The installation sequence is the reverse of
removal.
＊
When installing the exhaust muffler,
first tighten the two nuts on the front
and then tighten the two bolts.
Remove the spark plug.
Remove the cylinder head bolts and the
cylinder head.
＊
Loosen the bolts diagonally in 2 or 3
times.
Remove the cylinder head gasket.
SUPER 9
Spark Plug Cap
Exhaust muffler joint lock nut
Cylinder head Bolts
Spark Plug
50
Bolts
Cylinder Head
6-2