KYMCO SUPER 9 50 Service Manual page 155

13
. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Pack all bearing cavities with grease.
Drive in the left bearing.
Install the distance collar.
Drive in the right bearing.
＊
• Do not allow the bearings to tilt while
driving them in.
• Drive in the bearing squarely with the
sealed end facing out.
Special Tools
Outer driver
Driver handle
INSTALLATION
Apply grease to the speedometer gear unit.
Install the speedometer gear unit by aligning
its retaining pawl with the hub cutout.
＊
• If not aligned, the retaining pawl will
be deformed when the axle nut is
tightened.
• After installing the axle, turn the wheel
to make sure that the speedometer drive
shaft rotates freely.
Install the front wheel by aligning the
speedometer gear unit groove with the front
shock absorber tab.
Insert the axle and tighten the axle nut.
＊
When installing the front wheel, position
the brake disk between the two brake
pads.
Torque: 44.1～49.0N-m
13-7
Outer Driver
Speedometer Gear Unit
Hub Cutout Pawl
Groove
Speedometer Gear Unit
SUPER 9 50
Driver Handle
Tab