Enabling Embedded Web Server; Enabling Telnet; Connecting Cables To The Fibre Channel Ports; Connecting The Director To A Fabric - HP StorageWorks Director 2/140 Installation Manual

Enabling Embedded Web Server

Use the following steps to enable EWS:
1. At the Hardware View page, select Configure > Enable Web Server.
Selecting Enable Web Server automatically places a check in the box.
2. Select Enable Web Server again to remove the check and disable the EWS interface.
When disabled, remote users cannot access the interface.
For complete procedures on using EWS, refer to the HP StorageWorks Embedded Web Server user
guide.

Enabling Telnet

Use the following steps to enable Telnet:
1. At the Hardware View, select Configure > Enable Telnet.
Selecting Enable Telnet automatically places a check in the box.
2. Select Enable Telnet again to remove the check and disable telnet access.
When disabled, remote users cannot access the director through telnet.

Connecting cables to the Fibre Channel ports

Use these steps to connect Fibre Channel port cables:
1. Route the fiber-optic cables from customer-specified devices to ports at the front of the director.
2. Bundle Fibre Channel cables from the director and other equipment (groups of 16 maximum),
and secure them as directed by the customer.
3. Set the director online. For instructions, see "Setting the director online" on page 50.

Connecting the director to a fabric

To attach the director to a multi-switch fabric, connect the director to an E_Port of another director or
switch. The E_Port to E_Port connection is referred to as an ISL.
Use these steps to fabric-attach the director and create an ISL:
1. Verify that the director is defined via HAFM. See "Enabling HAFM to manage the director" on
page 46.
2. Verify that the preferred domain ID for the director is unique and does not conflict with the ID of
another director or switch participating in the fabric. To change the domain ID, see "Configuring
fabric parameters" on page 55.
3. Verify that the R_A_TOV and E_D_TOV values for the director are identical to the values for all
directors and edge switches participating in the fabric.
4. Route a multi-mode or single-mode fiber-optic cable (depending on the ISL distance between
directors) between customer-specified E_Ports on both directors.
5. At the HAFM application physical map, right-click the director product icon, and then select
Element Manager from the menu.
6. If required, click the Hardware tab.
72 Installing and configuring the director