Table of Contents
Advertisement
Installation instructions
3.5.5 Adjustment of hinged basket conveyor
•
•
•
•
3.5.6 Bleeding the hood lifting cylinder (option)
1.
2.
3.
4.
5.
3.5.7 Setting / adjustment of flows
This is described in the chapter ADJUSTMENT INSTRUCTIONS.
WD-PRM6 & WD-PRM7
Adjust the machine so that it is level by adjusting all four feet so that they
are in full contact with the floor. Use a spirit level.
Fill the machine.
Lift the basket conveyor (5) up and down and adjust leg (1) and leg (2) until
the basket conveyor is in the middle of both supports (3) and (4).
The legs must be adjusted in pairs if any further adjustment is required (to
the side, forwards or backwards).
Close the hood.
Loosen the hose connection of the first air cylinder approx. 2-3 turns using
a 13 mm box wrench.
Keep the hood in the closed position. Press the up button. Check that only
water and no air comes out of the hose connection. Otherwise repeat the
procedure.
Tighten the hose connection with the hood still in the lower position.
Repeat the same procedure with the second cylinder.
15
PRM_47747
Rev. 5.0 (201902)
Advertisement
Table of Contents
