Removing An Expansion Card From The Internal Perc Riser - Dell PowerEdge R530xd Owner's Manual

2. Follow the procedure listed in
3. If connected, disconnect the from expansion card (s).
4. If connected, remove the full length expansion card.
5. Remove the cooling shroud
6. If applicable, install the PERC card on the riser.
Steps
1. Align the guide slot on the internal PERC riser with the guide pin on the chassis.
2. Align the edge connector of the internal PERC riser with the PCIe connector on the system board.
3. Press down to lock the riser bracket to the chassis.
Next steps
1. Reconnect all disconnected cables.
2. Install the cooling shroud.
3. If removed, reinstall the full length expansion card.
4. If required, open the expansion card latch on the cooling shroud to support the full length expansion
card.
5. Follow the procedure listed in

Removing an expansion card from the internal PERC riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. If connected, disconnect the cables from the expansion card(s).
4. If required, remove the dual riser module.
NOTE: If required, close the expansion card latch on the cooling shroud to release the full
length card.
5. Remove the cooling shroud.
6. Remove the internal PERC riser.
NOTE: The internal riser can be used only when both the processors are installed.
Steps
1. Press the blue release tab to disengage the lock from the expansion card's locking notch.
2. Slide the expansion card out of the internal PERC riser, until the expansion card is free of the guide
slot on the internal PERC riser.
3. Lift the expansion card away from the system.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.
87