Replacing An Sd Vflash Media Card; Installing The Sd Vflash Card - Dell PowerEdge R530xd Owner's Manual

Replacing an SD vFlash media card

1. Locate the SD vFlash media slot at the back of the chassis.
2. To remove the SD vFlash media card, push the card inward to release it, and pull the card from the
card slot.
Figure 36. Removing and installing the SD vFlash media card
1. SD vFlash media card
3. To install an SD vFlash media card, insert the contact-pin end of the SD vFlash media card into the
card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
4. Press the card inward to lock it into the slot.

Installing the SD vFlash card

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in
System Setup.
Steps
1. Locate the SD card connector on the internal dual SD module. Align the SD card appropriately and
insert the contact-pin end of the card into the slot.
96
Safety instructions.
Before working inside your
2. SD vFlash media-card slot
system.