Installing The (Optional) 2.5 Inch Internal Hard Drive Cage - Dell PowerEdge R530xd Owner's Manual

7. Follow the procedure listed in
Related Tasks
Removing the (optional) dual riser module
Removing the cooling shroud
Removing the (optional) 2.5 inch internal hard drive carrier
Installing the (optional) 2.5 inch internal hard drive carrier
Installing the (optional) dual riser module
Installing the cooling shroud

Installing the (optional) 2.5 inch internal hard drive cage

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the #2 Phillips screwdriver ready.
4. If connected, disconnect the cables from expansion card (s).
5. If required, remove the PCIe expansion card riser.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full
length card.
6. Remove the cooling shroud.
7. Disconnect the power and data cables from the hard drive.
8. Disconnect the FAN1 cable from the power interposer board.
NOTE: The FAN1 cable is routed behind the internal hard drive cage.
Steps
1. Align the internal hard drive cage guide with the guide slots on the chassis.
2. Insert the internal hard drive cage into the chassis.
3. Secure the internal hard drive cage to the chassis.
Next steps
1. Install the internal hard drive carrier.
2. Reconnect the FAN1 cable to the power interposer board.
3. If removed, reinstall the PCIe expansion card riser.
4. If disconnected, reconnect the cables to the expansion card(s).
5. Reinstall the cooling shroud.
6. If required, open the expansion card latch on the cooling shroud to support the full length expansion
card.
7. Follow the procedure listed in
Related Tasks
Removing the (optional) dual riser module
Removing the cooling shroud
Installing the (optional) dual riser module
Installing the cooling shroud
After working inside your
Safety instructions.
Before working inside your
After working inside your
system.
system.
system.
75