Figure 39. Installing internal PERC riser
5. Connect the cables to the backplane and then route the cables to the cable guiding latch to close the latch.
Next steps
1.
Installing the air shroud
2. Follow the procedure listed in
Removing the PERC card from the internal PERC riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Removing the air shroud
4.
Removing the internal PERC riser
Steps
1. Using a Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser.
2. Pull the PERC card out of the connector on the internal PERC riser.
50
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.