Figure 35. Removing and installing the iDRAC ports card
1.
iDRAC ports card holder
3.
SD vFlash media card reader
5.
screws (2)
Next steps
1.
Install the expansion card riser.
2.
If applicable, connect the required power or data cables to the expansion card(s).
3.
Install the cooling shroud.
4.
If applicable, open the expansion card latch on the cooling shroud to support the full length
expansion card.
5.
Follow the procedure listed in
Related Tasks
Removing the cooling shroud
Installing the (optional) dual riser module
Installing the cooling shroud
94
After working inside your
2.
iDRAC port
4.
iDRAC ports card
6.
iDRAC ports card connector on system
board
system.