Hard Drive Backplane; Removing The Hard Drive Backplane - Dell PowerEdge R530xd Owner's Manual

1. positive side of battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the
securing tabs.
4. Press the battery into the connector until it snaps into place.
Next steps
1. If applicable, install the PCIe expansion card riser.
2. If applicable, connect the required power or data cables to the expansion card(s).
3. Reinstall the cooling shroud.
4. If applicable, open the expansion card latch on the cooling shroud to secure the full length
expansion card.
5. Follow the procedure listed in
6. While booting, press <F2> to enter the System Setup and ensure that the battery is operating
properly.
7. Enter the correct time and date in the System Setup Time and Date fields.
8. Exit the System Setup.
Related Tasks
Removing the cooling shroud
Removing the (optional) dual riser module
Installing the (optional) dual riser module
Installing the cooling shroud

Hard drive backplane

Removing the hard drive backplane

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the hard drives and hard drive backplane, you must remove the
hard drives from the system before removing the hard drive backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before
removal so that you can reinstall them in their original locations.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove all hard drives.
Steps
1. Disconnect the left ear control panel and right ear I/O module cables, SAS/SATA data cable(s), and
power cables from the hard-drive backplane.
122
After working inside your
Safety instructions.
Before working inside your
2. socket
system.
system.