Expansion Cards And Expansion Card Riser (Optional) - Dell PowerEdge R530xd Owner's Manual

NOTE: To locate the internal USB connector on the system board, see
connectors.
2. If installed, remove the USB key.
3. Insert the new USB key into the USB connector.
Figure 27. Replacing the internal USB key
1. USB memory key
Next steps
1. If removed, reinstall the full length PCIe expansion card.
2. If removed, reinstall the PCIe expansion card riser.
3. If disconnected, reconnect the cables to the expansion card(s).
4. Reinstall the cooling shroud.
5. Follow the procedure listed in
6. While booting, press <F2> to enter the System Setup and verify that the USB key is detected by the
system.
Related Tasks
Removing the (optional) dual riser module
Removing an expansion card from the dual riser module
Removing the cooling shroud
Installing an expansion card into the dual riser module
Installing the (optional) dual riser module
Installing the cooling shroud

Expansion cards and expansion card riser (optional)

NOTE: A missing or an unsupported expansion card riser logs an SEL event. It does not prevent your
system from powering on and no BIOS POST message or F1/F2 pause is displayed.
After working inside your
System board
2. USB memory key connector
system.
79