Installing The (Optional) Dual Riser Module - Dell PowerEdge R530xd Owner's Manual

Figure 29. Removing and installing the dual riser module
1. full height expansion card latch
3. expansion card riser (2)
Next steps
1. If removed, reinstall the expansion card(s) onto the dual riser module.
2. If disconnected, connect the power or data cables to the expansion card(s).
3. Install the dual riser module.
4. Follow the procedure listed in

Installing the (optional) dual riser module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Install the expansion card on to the dual riser module, if applicable.
NOTE: Ensure that the expansion card is properly seated along the chassis, so that the
expansion card latch can be closed.
Steps
1. Align the dual riser module with the guide pins on the chassis near PCIe slots 1 and 2.
2. Insert the dual riser module into the chassis and press the module to lock it into place.
84
After working inside your
Safety instructions.
Before working inside your
2. dual riser module
4. PCIe connector on the system board (2)
system.
system.