Removing The Perc Card From The Internal Perc Riser; Installing Perc Card Into The Internal Perc Riser - Dell EMC PowerEdge R440 Installation And Service Manual

Removing the PERC card from the internal PERC riser

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the internal PERC riser.
Steps
1. Using a Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser.
2. Pull the PERC card out of the connector on the internal PERC riser.
Figure 52. Removing the PERC card from the internal PERC riser
Next steps
1. Install the PERC card into the internal PERC riser.
2. Replace the air shroud.
3. Follow the procedure listed in

Installing PERC card into the internal PERC riser

Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Insert the PERC card into the internal PERC riser and push the card in.
2. Using a Phillips #2 screwdriver, replace the screw to secure the PERC card on the internal PERC riser.
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
system.
system.
Installing and removing system components 61