Table of Contents
Advertisement
4.
If required, remove the PCIe expansion card riser.
5.
Remove the cooling shroud.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full
length card.
6.
Disconnect the power and data cables from the internal hard drive.
Steps
1.
Lift the handle-lock to the open position
2.
Lift the 2.5 inch internal hard drive carrier out of the chassis.
Figure 23. Removing and installing the 2.5 inch internal hard drive carrier
1.
internal hard drive carrier guide
3.
handle-lock
5.
hard drive retention screw (8)
7.
lock guide pin
Next steps
1.
Install the 2.5 inch internal hard drive carrier.
2.
Reconnect the power and data cables to the internal hard drives.
70
2.
internal hard drive carrier
4.
lock guide
6.
internal hard drive cage
8.
guide slot
Advertisement
Table of Contents
Troubleshooting
