Table of Contents
Advertisement
3.
Disconnect the data, signal and power cables to the backplane.
4.
Remove all SAS/SATA/SSD hard drives.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Use the hooks on the chassis as guides to align the hard drive backplane to the chassis.
2.
Lower the hard drive backplane until the release tabs snap into place.
3.
Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.
Next steps
1.
Install all SAS/SATA/SSD hard drives in their original locations.
2.
Reconnect the data, signal and power cables to the backplane.
3.
Follow the procedure listed in
Related Tasks
Removing a hot-swappable hard drive carrier
Installing a hot-swap hard drive
Control panel and I/O module
Removing the control panel
Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
3.
Keep the T15 Torx screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: Do not use excessive force when removing the control panel cable as it can damage
the connectors.
Steps
1.
Disconnect the control panel cable from the hard drive backplane by pulling on the plastic pull tab.
2.
Remove the screws that secure the control panel to the chassis.
3.
Fold the plastic pull tab close to the connector.
4.
Pull out the control panel cable as you guide the connector and the plastic pull tab through the
channel on the chassis.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
127
Advertisement
Table of Contents
Troubleshooting
