Table of Contents
Advertisement
3.
Reconnect the system to its electrical outlet.
4.
Turn the system on, including any attached peripherals.
Related Tasks
Installing the system cover
Installing the front bezel
Recommended tools
You need the following tools to perform the removal and installation procedures:
•
Key to the front bezel lock. This is required only if you have a front bezel.
•
#1 Phillips screwdriver
•
#2 Phillips screwdriver
•
#T15 Torx screwdriver
The following tools are required for assembling the cables for a DC power supply unit (PSU):
•
AMP 90871-1 or Tyco Electronics 58433-3 or equivalent hand-crimping tool
•
Wire-stripper pliers capable of removing insulation from size 10 AWG solid or stranded, insulated
copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
Front bezel (optional)
Removing the front bezel
1.
Unlock the bezel.
2.
Lift the release latch next to the lock.
3.
Rotate the left end of the bezel away from the front panel.
4.
Unhook the right end of the bezel and pull the bezel away from the system.
43
Advertisement
Table of Contents
Troubleshooting
