Documentation Matrix - Dell PowerEdge R530xd Owner's Manual

Convention Power indicator
pattern
A Green
B Flashing green
C Flashing amber
D Not lit

Documentation matrix

The documentation matrix provides information on documents that you can refer to for setting up and
managing your system.
To...
Install your system into a rack
Set up your system and know the system technical
specifications
Install the operating system
Get an overview of the Dell Systems Management
offerings
Configure and log in to iDRAC, set up managed
and management system, know the iDRAC
features and troubleshoot using iDRAC
Know about the RACADM subcommands and
supported RACADM interfaces
Condition
The handle/LED indicator lights green indicating that a valid power
source is connected to the PSU and that the PSU is operational.
When hot-adding a PSU, the handle of the new power supply unit
flashes green five times at 4 Hz rate and turns off. This indicates
that the new PSU is mismatched with the PSU that is installed (in
terms of efficiency, feature set, health status, and supported
voltage). Use a PSU that matches the capacity of the PSU that is
installed.
Indicates a problem with the PSU.
CAUTION: When correcting a PSU mismatch, replace only
the PSU with the flashing indicator. Swapping the opposite
PSU to make a matched pair can result in an error condition
and unexpected system shutdown. To change from a High
Output configuration to a Low Output configuration or vice
versa, you must power down the system.
CAUTION: If two power supplies are used, they must be of
the same type and have the same maximum output power.
CAUTION: Combining AC and DC power supplies is not
supported and triggers a mismatch.
Power is not connected.
Refer to...
Rack documentation included with your rack
solution
Getting Started With Your System that shipped with
your system or see dell.com/poweredgemanuals
Operating system documentation at dell.com/
operatingsystemmanuals
Dell OpenManage Systems Management Overview
Guide at dell.com/openmanagemanuals
Integrated Dell Remote Access Controller User's
Guide at dell.com/esmmanuals
RACADM Command Line Reference Guide for
iDRAC and CMC at dell.com/esmmanuals
19