Removing An Expansion Card From The Internal Perc Riser - Dell DSS 2500 Owner's Manual

Removing an expansion card from the internal PERC riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If connected, disconnect the cables from the expansion card(s).
4 If required, remove the dual riser module.
NOTE: If required, close the expansion card latch on the cooling shroud to release the full length card.
5 Remove the cooling shroud.
6 Remove the internal PERC riser.
NOTE: The internal riser can be used only when both the processors are installed.
Steps
1 Press the blue release tab to disengage the lock from locking notch of the expansion card.
2 Slide the expansion card out of the internal PERC riser, until the expansion card is free of the guide slot on the internal PERC riser.
3 Lift the expansion card away from the system.
Figure 43. Removing an expansion card on the internal PERC riser
1 expansion card guide slot on internal PERC riser
100 Installing and removing system components
2 expansion card