Table of Contents
Advertisement
2. Click Browse to select a picture.
3. Click Upload to upload it.
4. Check Enable Picture Overlay checkbox to enable the function.
X Coordinate and Y Coordinate values are for the location of the picture on the
image. And the Picture width and height shows the size of the picture.
5. Click Save to save the settings.
5.5.6 Configuring DPC (Defective Pixel Correction)
Purpose:
DPC (Defective Pixel Correction) refers to the function that the camera can correct
the defective pixels on the LCD which are not performing as expected.
Note:
This function is only available to certain camera models.
Steps:
1. Enter the DPC Settings interface.
Configuration > Advanced Configuration> Image > DPC
2. Click on the image to select the defective pixel. The cursor on the image will
move to the clicked position. You can click
position.
3. Click
to start correction.
Thermometric Network Bullet Camera User Manual
Figure 5-34 Picture Overlay
to slightly adjust the cursor
62
Advertisement
Table of Contents
