HIKVISION UD02330B User Manual page 30


Live View Parameters: Set the protocol type and live view performance.
●
Protocol Type: TCP, UDP, MULTICAST and HTTP are selectable.
TCP: Ensures complete delivery of streaming data and better video quality,
yet the real-time transmission will be affected.
UDP: Provides real-time audio and video streams.
HTTP: Allows the same quality as of TCP without setting specific ports for
streaming under some network environments.
MULTICAST: It's recommended to select MCAST type when using the
Multicast function. For detailed information about Multicast, refer to Section
5.3.1 Configuring TCP/IP Settings.
●
Live View Performance: Set the live view performance to Shortest Delay or
Auto.
●
Auto Start Live View: If you enable this function, live view images will be
automatically started when Live View tab is activated. If the function is
disabled, you can also manually start live view in the Live View interface.
●
Rules: It refers to the rules on your local browser, select enable or disable to
display or not display the colored marks when the motion detection, face
detection, or intrusion detection is triggered. E.g., enabled as the rules are, and
the face detection is enabled as well, when a face is detected, it will be marked
with a green rectangle on the live view.
●
Image Format: Choose the image format for picture capture.
●
Fire Point: Select Fire Source Detection as VCA Resource Type. Check the
checkbox to enable the functions required. Display Fire Point Distance,
Display Highest Temperature, Locate Highest Temperature Point and Frame
Fire Point are selectable.
●
Display Temperature Info. on Stream: Select Temperature Measurement as
VCA Resource Type. Check the checkbox to display the temperature
information on the live view interface.
●
Display Temperature Info. on Capture: Select Temperature Measurement as
VCA Resource Type. Check the checkbox to display the temperature
Thermometric Network Bullet Camera User Manual
30