Advertisement
Quick Links
TURBO HD TVI
Bullet & Turret & Dome
Camera
User Manual
UD04829B
User Manual
Thank you for purchasing our product. If there are any
questions, or requests, do not hesitate to contact the
dealer.
This manual applies to the model listed below.
Type
Type I
Type II
Type III
Type IV
This manual may contain several technically incorrect
places or printing errors, and the content is subject to
change without notice. The updates will be added to the
new version of this manual. We will readily improve or
update the products or procedures described in the
manual.
Model
DS-2CE16D0T-VFIR3F
DS-2CE16C0T-VFIR3F
DS-2CE56D0T-VFIR3F
DS-2CE56C0T-VFIR3F
DS-2CE56D0T-VPIR3F
DS-2CE56C0T-VPIR3F
DS-2CE56D0T-VFIRF
DS-2CE56C0T-VFIRF
0100001070320
Advertisement
Related Manuals for HIKVISION UD04829B
Summary of Contents for HIKVISION UD04829B
- Page 1 TURBO HD TVI Bullet & Turret & Dome Camera User Manual UD04829B User Manual Thank you for purchasing our product. If there are any questions, or requests, do not hesitate to contact the dealer. This manual applies to the model listed below.
-
Page 2: Regulatory Information
Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. - Page 3 Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected.
-
Page 4: Product Features
While in delivery, the camera shall be packed in its original packing, or packing of the same texture. Introduction Product Features The camera is applicable for both indoor and outdoor conditions, and the application scenarios include road, warehouse, parking lot, office, campus, etc.. The main features are as follows: High performance CMOS sensor ... -
Page 5: Installation Preparation
1.2.3 Type III Camera Overview Power Cord Lens (12 VDC) Video Cable (TVI) Switch Black Liner Button Back Box Bubble Figure 1. 3 Type III Camera Overview Note: Press and hold the switch button for 5 seconds to switch the video output. Four kinds of video outputs are available: TVI, AHD, CVI, and CVBS. - Page 6 Installation of Type I Camera Before you start: Both wall mounting and ceiling mounting are suitable for the bullet camera. Ceiling mounting will be taken as an example in this section. You can take the steps of ceiling mounting as a reference when adopting wall mounting. Steps: 1.
- Page 7 Figure 2. 3 3-Axis Adjustment 1). Loosen the No.1 adjusting screw to adjust the pan position [0° to 360°]. 2). Tighten the No.1 adjusting screw. 3). Loosen the No.2 adjusting screw to adjust the tilting position [0° to 90°]. 4). Tighten the No. 2 adjusting screw. 5).
- Page 8 Figure 2. 6 Fix the Mounting Base on the Ceiling Note: The supplied screw package contains self-tapping screws, and expansion bolts. For cement wall, expansion bolts are required to fix the camera. For wooden wall, self-tapping screws are required.
- Page 9 Installation of Type III and Type IV Camera Before you start: Both wall mounting and ceiling mounting are suitable for the dome camera. Ceiling mounting will be taken as an example in this section. You can take the steps of ceiling mounting as a reference when adopting wall mounting.
- Page 10 For cement wall, expansion bolts are required to fix the camera. For wooden wall, self-tapping screws are required. 5. Route the cables through the cable hole (optional), or the side opening. 6. Align the camera with the back box/base plate, and secure the camera with the back box/base plate.