2. Select the Time Zone.
Select the Time Zone of your location from the drop-down menu.
3. Set Time Synchronization.
You can synchronize the time through NTP, or you can do it manually.
●
Synchronizing Time by NTP Server.
(1) Check the checkbox to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions with
NTP server.
Note:
If the camera is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the
National Time Center (IP Address: 210.72.145.44). If the camera is set in a
customized network, NTP software can be used to establish a NTP server for
time synchronization.
Thermometric Network Bullet Camera User Manual
Figure 5-2 Time Settings
Figure 5-3 Time Sync by NTP Server
32