Modifying A Saved Configuration - Printronix SL4M User Manual

Chapter 4

Modifying A Saved Configuration

Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel Centronics interface instead of the
IEEE 1284 interface.
1. Load the configuration to be changed (for example, Config. 1).
a. Press the
b. Press the Right key until the following displays:
c. Press the ↵ key to enter the CONFIGURATION menu.
d. Press the Down key until the following displays:
e. Press the Left or Right keys to cycle through the options Factory, 1-8.
f.
2. Move through the menu and change all the desired values. (In this
example, press the
displays. Press the Right key until Select: IGL displays.
3. Press the ↵ key to select each new value. An asterisk (*) displays.
4. Before saving the modified configuration, you must delete the original
configuration if the Protect Config. option is enabled.
a. Press the Up or Down keys until the following message displays:
140
. .
key to enter the menu configuration. MEDIA SETUP is
.
selected.
CONFIGURATION
Load Config.
1*
When the desired number displays, press the ↵ key to select it. The
following message displays:
Loading Saved
Configuration
Then, the following message displays when it is loaded:
Load Config.
X *
. .
key then the Right key until EMULATION
.
Delete Config.
1*