Loading A Saved Configuration; Run A Barcode Demo Test - Printronix SL5000E Quick Setup Manual

3. Press + or – until the desired configuration displays.
4. Press

Loading A Saved Configuration

To use a different configuration, load a saved configuration:
1. Press the PAUSE key until OFFLINE displays.
2. Press the JOB SELECT key until the desired configuration
3. Press

Run A Barcode Demo Test

IMPORTANT
Printronix recommends using the supplied starter roll of 100
labels to set up and verify printer operation. If you have an
SL5000e, this will avoid expending the more expensive smart
labels for this task.
Before you send an actual print job, run a barcode demo test:
1. Press the PAUSE key until OFFLINE displays.
2. Press TEST PRINT until Printer Tests / Barcode Demo
3. Press
4. Check the test pattern. If necessary, reposition the pressure
5. If desired, you can run additional printer tests, such as Grey,
NOTE: These tests run continuously by default. Press
↵
. An asterisk (*) displays next to the selected
configuration.
displays.
↵
. Loading Saved / Configuration displays.
displays.
↵
. The Barcode Demo test pattern will start and print two
barcodes.
blocks to obtain a uniform print quality. In most cases, you will
need to adjust only the right pressure block.
Grid, and Checkerboard. See step 1 above to start other tests.
test.
Repacking The Printer
QUICK SETUP Menu Items
↵
to end the
49