Sensor Setup Menu - Printronix SL4M User Manual

TOF Adjust
This opton sets the distance from the Top Of Form (TOF) that is left blank
(unprinted) after a label has been removed in Tear-Off Strip. Normally printing
is done starting at TOF, but when this mode is enabled the start position for
printing can be adjusted from 0.00 to 0.40 inches from TOF (in increments of
0.01 inch). This adjustment can be helpful if a die cut label sticks to the platen
by means of jagged edges created during a poor die cut label removal using
the tear bar. By controlling how much blank space there is from TOF, you can
control how much the media is called back after it is torn off.

SENSOR SETUP Menu

SENSOR
SETUP
(from page 66)
Gap/Mark Run Auto-Cal
Sensor
Gap*
Disable
Mark
Paper Out Run Manual
4
Thresh Cal
2
190
000 to 255
Gap Length Cal in Peel
0.12 inches* Disable*
0.05 to 1.00 inches Enable
Notes:
* = Factory Default
Italicized items are available only when you enable Admin User (in the PRINTER SETUP menu).
1
If Gap/Mark Sensor (in the SENSOR SETUP menu) is set for Gap sensing, the factory default is 140.
If Gap/Mark Sensor is set for Mark, the factory default is 75.
2
If Gap/Mark Sensor (in the SENSOR SETUP menu) is set for Gap or Disable sensing, the factory default is 190.
If Gap/Mark Sensor is set for Mark, the factory default is 150.
3
You can change the unit value to millimeters. Set Units submenu to "In Millimeters" (in the MEDIA SETUP menu).
4
The value range varies depending on calibration results.
5
This option applies only when Gap/Mark Sensor is set to Mark.
Run Profile
Sensed
Distance
0.00 inches
0.01 inches to xx inches
Pwr Up
Auto-Cal Auto-Cal
Enable* Enable*
Disable Disable
Min Calib
Mode Delta
20*
012 to 050
SENSOR SETUP Menu
MEDIA SETUP Submenus
Gap/Mark
Thresh
3 1
140
4
000 to 255
Head
Online
Auto-Cal
Disable*
Enable
Use Label Threshold
Length Range
Disable* 50%*
Enable 5% to 95%
4
Gap
Windowing
Disable*
Enable
Mark TOF
5
Detect
Mark Trail Edge*
Mark Lead Edge
79