Printronix SL4M User Manual page 181

Displayed Message
ERROR: INSUFFICIENT
DRAM
Cycle Power
ERROR: INSUFFICIENT
FLASH
Cycle Power
ERROR: WRONG
CHECKSUM
Repeat Download
ERROR OCCURRED:
CLEARING QUEUES
Please Wait
FILE SYS WRITE
Check Flash
Table 15. Fault Messages
Can User
Explanation
Correct?
Yes/No Not enough RAM
memory available for a
printer function.
Yes The printer requires
more flash memory to
run the downloaded
program.
Yes The printer received the
complete program but
the checksum did not
match. The data may
have been corrupted
during download.
Yes An interim message
displays while the
printer discards host
data it cannot use
because a fault
condition exists. While
this message displays,
the asterisk (*) rotates.
Yes/No Problem writing to flash
memory.
Fault Messages
Solution
1. Power off the printer for
15 seconds, then power
back on again.
2. If the message
reappears, increase the
Glob Mem Adjust size in
the PRINTER SETUP
menu and reboot the
printer.
3. If the message
reappears, replace the
controller PCBA. Write
down the message and
return it with the
defective board.
Power off the printer for 15
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
Power off the printer for 15
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
Wait. When the asterisk (*)
stops rotating, a different
fault message will appear;
troubleshoot the final
message.
Power off the printer for 15
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
181