Printronix SL4M User Manual page 215

NOTE: The alternate ribbon path is for inside ink ribbon.
Alternate
Ribbon Path
Media
Media
Guide
Media Guide
Roller
Front Door
Opening
Alternate Rewind Path
3. Loosen the thumbscrew, pull it outward, position the wind direction lever
NOTE: Wind direction lever in lower position = clockwise rotation.
IMPORTANT
If you do not complete the following step, it will be extremely difficult to
remove the printed labels from the rewinder.
4. Remove the media rewinder clip.
5. Wrap the leading edge of the media around the rewinder.
6. Slide the media flush against the left edge of the rewinder.
The alternate media path is for inside wound label path.
Thumbscrew
NOTE: The wind direction lever
(not shown) is located behind
the thumbscrew.
Figure 9. Ribbon Rewind Path
in the desired location, and tighten the thumbscrew. See Figure 9.
Wind direction lever in upper position = counterclockwise rotation.
Using The Batch Label Rewinder Option
Rewinder
Rewinder Full
Sensor
Load Media
Alternate
Media Path
Thumbscrew
215