Printronix SL4M User Manual page 192

Chapter 6
Restore The Printer To Operation
Displayed Message
LOADING PROGRAM
FROM PORT XX%
LOADING PROGRAM
INTO FLASH
MEMORY REMOVED
Check EMC
MENU MODE
MEDIA SETUP
MEDIA OUT
Load Media
192
Table 15. Fault Messages
Can User
Explanation
Correct?
Yes The new emulation
program is loading into
printer RAM. XX%
indicates how much of
the program has
loaded.
Yes A program is getting
loaded into flash.
Yes The EMC was removed
while the printer was
powered on.
Yes Normal message that
displays when you first
press the MENU key to
place the printer in
Menu mode when no
validator option is
installed.
Yes The printer does not
sense media:
•
Media was not
installed or has run
out.
•
A break in media
has occurred.
•
Media was not
routed or installed
correctly.
•
The media sensor
is not positioned
correctly.
•
Media is installed
correctly, but the
sensor is not
detecting it.
•
Gap/Mark Thresh
value may be set
too high and/or
Paper Out Thresh
may be set too low.
Solution
No action required.
No action required.
1. Power off the printer.
2. Install the EMC.
3. Power on the printer.
No action required.
1. Install media. If a break
occurred, reinstall the
media. Press the Pause
key to clear the fault
message. Check the
media installation
procedures on page 25.
2. Verify the media sensor
is properly positioned.
Run Auto-Cal to improve
the ability of the sensor
to detect the installed
media.
3. Check if the Gap/Mark
Thresh is too high or the
Paper Out Thresh is too
low. Lower the Gap/
Mark Thresh or raise the
Paper Out Thresh value.
4. If using media with no
gaps or black marks,
perform Run Auto-Cal to
establish a valid Paper
Out Thresh.