Appendix B
Using The Peel-Liner Rewinder Option
Load Media
Pivoting
Deck
Label
Knurled
Roller
Peel-Off
Door
Platen
Rubber
Roller
Figure 11. Loading Media on the Peel-Liner Rewinder
1. Open the media cover.
2. Open the side cover and refer to the Label and Ribbon Routes label on
the inside of the side cover.
3. Open the pivoting deck by rotating the deck lock lever fully
counterclockwise.
4. Open the peel-off door by pulling it upward, then forward.
5. Remove approximately 18 to 24 inches of labels from the liner. This will
prevent the labels from sticking to the tear bar during the initial print feed.
218
Media Cover
Deck Lock Lever
Media Damper
Rewinder
Media
Rewinder Clip
Side Cover