Printronix SL4M User Manual page 219

6. Thread the media under the media damper, over the platen, and in
between the knurled roller and the rubber roller. See Figure 11 and
Figure 12.
7. Thread the liner under the rubber roller.
8. Remove the media rewinder clip.
Pivoting
Deck
Alternate
Ribbon Path
Label
Platen
Tear
Bar
Peel-Off Door
Knurled Roller
(open position)
Knurled Roller
(closed position)
Figure 12. Peel-Liner Rewinder Media Path
9. Wrap the leading edge of the liner over and around the rewinder.
10. If necessary, loosen the thumbscrew, pull it outward, position the wind
direction lever in the lower position, and tighten the thumbscrew.
See Figure 12.
NOTE: Wind direction lever in lower position = clockwise rotation.
11. Slide the liner flush against the left edge of the rewinder.
Using The Peel-Liner Rewinder Option
Rubber Roller
Liner
Thumbscrew
NOTE: The wind direction lever
(not shown) is located behind
the thumbscrew.
Load Media
Media
Alternate
Media Path
Rewinder
219