Printronix SL4M User Manual page 118

Chapter 4
INTERFACE Menu
•
Dial Method
•
•
•
PNE Port Number. This menu selects the port number the printer
expects the PNE to connect through. The factory default is 3001 and the
range is from 1023 to 65535.
•
PNE Port Timeout. If the PNE has not communicated to the printer within
a timeout period, the PNE session closes. The factory default is 100
seconds. The range is from 1 to 255 seconds.
•
Status Port Number. This is the Ethernet Port number the emulations
can use to communicate status to the host computer.
•
Mgmt Port Number. This is the Ethernet Port number the PXML or UCP
will use to communicate to the printer.
Serial Port
•
Baud Rate. Sets the baud rate of the serial interface in the printer. Baud
rate is the speed at which serial data is transferred between the host
computer and the printer. The options for the RS-232 interface are 600,
1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200 Baud.
NOTE: If you select a baud rate that is greater than 19200 and you
The factory default is 9600.
•
Word Length. Sets the length of the serial data word. The length of the
data word can be set to 7 or 8 bits and must match the corresponding
data bits setting in the host computer.
The factory default is 8.
•
Stop Bits. Sets the number of stop bits in the serial data word. Either 1 or
2 stop bits can be selected. The setting must match the corresponding
stop bit setting in the host computer.
The factory default is 1.
•
Parity. The options are Odd, Even, Mark, Sense, or None (factory
default). The setting must match the corresponding parity setting in the
host computer.
118
Tone (factory default). Sets the modem to use the tone dialing
method.
Pulse. Sets the modem to use the pulse dialing method.
experience data loss, you may need to lower the baud rate.
The factory default is 16K.