Printronix SL4M User Manual page 179

Displayed Message
B23 ERROR:
DECOMPRESS CKSUM
Repeat Download
BAD VFU CHANNEL
CALIBRATION FAIL
See User Manual
CANNOT CALIBRATE
Disable Peel-Off
CUTTER FAULT
Jam or Cut Fail
DOWNLOADER ERROR
BEYOND XXMB EMC
Repeat Download
Table 15. Fault Messages
Can User
Explanation
Correct?
Yes Problem when
downloading.
Yes The user tried to use an
undefined VFU
channel.
Yes Calibration values
derirved from Manual
Calibrate were not
acceptable.
Yes Run Auto-Calibrate was
attempted with Peel-Off
Media Handling
selected.
NOTE: You can
perform Auto Calibrate
in Peel-Off mode if Cal
in Peel Mode = Enable.
Be prepared to catch
labels during Run
Auto-Calibrate.
Yes 1. Cutter assembly is
not in the closed
position.
2. Cutter option was
not able to
complete a full cut
cycle due to a jam.
3. Cutter PCBA
detected current
overload and
opened circuit
breaker on cutter
PCBA.
No Printer contains an
XX MB EMC and the
firmware attempted to
access the EMC
beyond its limit.
NOTE: XX represents
the number of
Megabytes.
Fault Messages
Solution
Cycle power. If problem
persists repeat download.
Use defined channels.
Perform a Run Manual Cal
(run manual calibrate) again.
1. Select another Media
Handling option in the
MEDIA SETUP menu.
2. Enable Cal in Peel Mode
in the SENSOR SETUP
menu.
NOTE: Admin User must
= Enable in the
PRINTER SETUP menu.
1. Place the cutter
assembly in the closed
(up) position.
2. Clear obstruction from
the cutter assembly.
3. Insure media thickness
is within specification.
Wait a few minutes for
the cutter circuit breaker
to automatically reset.
Press (PAUSE) to
clear the fault message
and resume printing.
Contact your authorized
service representative.
179