Printronix SL4M User Manual page 193

Displayed Message
MODE NOT
COMPATIBLE WITH
CUTTER
Check Media Mode
NON VOLATILE
MEMORY FAILED
OPTION NOT
INSTALLED
Table 15. Fault Messages
Can User
Explanation
Correct?
Yes Peel-Off Media
Handling selection was
attempted with the
cutter option still
installed. This mode
requires that the front
door assembly be
installed to use the
Label Taken Sensor.
Yes/No The printer assigns a
certain amount of
simulated NVRAM for
storage of saved
configurations. Large
emulations reduce the
amount of space
available for saving
configurations, which
means that sometimes
fewer than eight
configurations can be
saved. If this message
appears when saving a
configuration, it means
the printer is out of
memory. Previously
saved configurations
will still be available, but
the one that was
"saved" when the
message appeared is
not in memory. If this
message appears at
power-up, it means the
flash memory is
defective.
Yes The printer is powered
on with the cutter not
connected correctly.
Fault Messages
Solution
Select a different Media
Handling Mode.
1. If the message appears
at power-up, call your
authorized customer
service representative.
2. If the message appears
while saving a
configuration, the printer
is out of memory and will
not save that or
subsequent
configurations.
(Previously saved
configurations are still
okay.)
3. Limit the number of
saved configurations to
seven.
1. Check that the cutter
option is installed and
connected correctly
before powering on the
printer.
2. If the error persists,
contact your authorized
customer service
representative.
193