Printronix SL4M User Manual page 77

•
An occasional blank label appears within a print job (in between
printed labels).
When Clip Page is set to Disable, the printer ignores any pre-printed dark
marks or multiple gaps on a label that could mistakenly be detected as
the next top-of-form position based on the specified Label Length value.
The Label Length option is in the MEDIA SETUP menu.
NOTE: When Clip Page = Disable, the correct Label Length value must be
entered. If the value is too long, the printer will ignore the actual gap
or mark it needs to detect. When using Gap sensing, the Label
Length value is equal to the physical length of a die cut or removable
label. When using Mark sensing, the Label Length value is the
physical distance from the leading edge of one black mark to the
leading edge of the next black mark.
Fault Reprint
This option determines how the printer handles data that was printing when
an error occurred.
•
Disable (factory default). The printer will not reprint the label that was
printing when the error condition occurred.
•
Enable. The printer reprints the label that was printing when the error
condition occurred.
Display Ribbon
When enabled and the printer is online, after some number of labels have
been fed, "Ribbon Life" and 1 to 4 asterisks will display on the last line of the
LCD indicating the approximate amount of ribbon remaining on the supply
spindle, based on a standard 450m ribbon. An exact value cannot be
determined, since ribbon thickness and roll lengths vary:
Ribbon Life **** = Full to 3/4 full
Ribbon Life -*** = less than 3/4 to 1/2 full
Ribbon Life --** = less than 1/2 to 1/4 full
Ribbon Life ---* = less than 1/4 to 1/8 full
The options are Enable (factory default) and Disable.
Display Ribbon displays if Admin User is set to Enable in the PRINTER
SETUP menu.
Ribbon Low
When enabled, and the ribbon remaining on the supply spindle is less than
1/8 full, the Attention indicator will flash, and "Ribbon Low" displays on the last
line of the LCD. A Ribbon Low warning will not prevent printing.
The options are Disable (factory default) and Enable.
Ribbon Low displays if Admin User is set to Enable in the PRINTER SETUP
menu.
MEDIA SETUP Submenus
77