Table of Contents
Advertisement
Table 3-7. SCSISelect Setup Configurations (Continued)
OPTION
Advanced Configuration Options
Reset SCSI Bus at IC Initialization
Extended BIOS Translation for DOS Drives >1
Gbyte
Host Adapter BIOS (Configuration Utility
Reserves BIOS Space)
Support Removable Disks
Under BIOS as Fixed Disks
Display <Ctrl-A> Messages During BIOS
Initialization
BIOS Support for Bootable CD-ROM
BIOS Support for Int13 Extensions
1
No effect if BIOS is disabled.
2
Do not remove media from a removable media drive if it is under BIOS control.
3
Set to Disable if NetWare 3.12 or 4.11 Network Operating System is installed.
Exiting SCSISelect
To exit SCSISelect, press ESC until a message prompts you to exit (if you changed any
settings, you are prompted to save the changes before you exit).
Optional RAID Controller
Factory Installed Controllers
The RAID options available for your system are the dual channel Mylex AcceleRAID
150 (SecuRAID 110) and Mylex AcceleRAID
boards, which gives your system the added security of fault tolerance.
If you order a system with a RAID controller, the system is pre-configured at the
factory. Refer to the "RAID Configurations" table below to determine how the RAID
controller was configured at the factory. If you want to reconfigure disk arrays and
logical drives, you must run the AcceleRAID
Configuration Utility; if you want to change the RAID level, you must run the Mylex
Disk Array Controller Utilities (DACCF) software. Refer to the AcceleRAID
AcceleRAID
running the AcceleRAID
the DACCF utility.
3-16 Configuring Your System
1, 2
™
250 documentation included with your system for information on
™
150 or AcceleRAID
RECOMMENDED SETTING
OR DISPLAY ONLY
Press ENTER for menu.
Enabled
Enabled
1
Enabled
1
Boot Only
1
Enabled
1
Disabled
1
Enabled
™
250 (SecuRAID 210) Controller
™
150 or AcceleRAID
™
250 BIOS Configuration Utility and
YOUR CONFIGURATION
™
250 BIOS
™
150 or
™
Advertisement
Table of Contents
Troubleshooting
