Cd-Rom Drive Activity Light Does Not Light; Problems With Application Software; Press F2 Key To Enter Setup: Prompt Does Not Display - NEC LC1400 Service & Reference Manual

CD-ROM Drive Activity Light Does Not Light

Check the following:
n
Is the power and signal cable to the CD-ROM drive properly installed?
n
Are all relevant switches and jumpers on the drive set correctly?
n
Is the drive properly configured?
n
Is the onboard IDE controller enabled?

Problems with Application Software

If you have problems with application software, perform the following:
n
Verify that the software is properly configured for the system. Refer to the software
installation and operation documentation for instructions on setting up and using the
software.
n
Verify a different copy of the software to see if the problem is with the copy that you
are using.
n
Make sure all cables are installed correctly.
n
Verify that the system board jumpers are set correctly. Refer to the "Configuring
Your System" chapter for jumper settings.
n
If other software runs correctly on the system, contact your vendor about the failing
software.
If the problem persists, contact the software vendor's customer service representative
for assistance.

Press F2 Key to Enter Setup: Prompt Does Not Display

If the prompt "Press F2 key to run Setup" does not appear at system startup, then the
prompt option has been disabled in the SSU. To enable the prompt:
n
Reboot the system using your SSU diskette 1, and go into the SSU to enable the
prompt.
5-12 Problem Solving