Removing A 5.25-Inch Media Device - NEC EXPRESS5800/120Lf User Manual

10. Connect the SCSI interface cable (see Figure 4-33) to the device.
A
B
C
D
E
11. Connect the power cable to the device.
12. Reinstall the left-hand side access panel on the system chassis. See Installing
the Side Access Panel earlier in this chapter.
13. Plug in the system power cord(s), and turn on the system.

Removing a 5.25-Inch Media Device

1. Perform Steps 1, 2, and 3 of Installing a 5.25-Inch Media Device described
earlier in this chapter.
2. Disconnect the SCSI interface cable and voltage cable from the rear of the
device you are removing.
3. Remove the two screws securing the device to the removable media device
bay. See Figure 4-32.
4. Slide the removable media device out of the device bay and set it down on
an antistatic surface.
Observe static precautions. Use an antistatic wrist strap.
5. Remove the screws securing the device mounting rails to the device and set
the rails and screws aside for future use. See Figure 4-31.
6. To install a replacement device, perform steps 5 through 16 of Installing a
5.25-Inch Media Device described earlier in this chapter. Otherwise,
continue with the next step.
7. Install a dummy cover into the vacated bay (see Figure 4-30).
8. Reinstall the left-hand side access panel on the system chassis. See Installing
the Side Access Panel earlier in this chapter.
9. Plug in the system power cord(s) and turn on the system.
A
B
System board SCSI connector
Not used
5.25-inch device bay SCSI connector for slot 1
5.25-inch device bay SCSI connector for slot 2
Terminator
Figure 4-33. SCSI Interface Cable
! CAUTION
D
C
Upgrading Your System 4-35
E