Configuring Advanced Settings; Configuring Pppoe Settings; Configuring Ddns - Epcom S04 S Series User Manual

SERIES SERIES

9.2 Configuring Advanced Settings

9.2.1 Configuring PPPoE Settings

Purpose:
Your device also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the PPPoE tab to enter the PPPoE Settings interface.
3. Check the PPPoE checkbox to enable this feature.
4. Enter User Name and Password for PPPoE access.
The User Name and Password should be assigned by your ISP.
5. Click the Apply button to save and exit the interface.
6. After successful settings, the system asks you to reboot the device to enable the new settings, and the PPPoE dial-up is
automatically connected after reboot.
You can go to Menu>Maintenance>System Info>Network interface to view the status of PPPoE connection. Please refer
to Chapter 11.1Viewing System Information for PPPoE status.

9.2.2 Configuring DDNS

Purpose:
If your device is set to use PPPoE as its default network connection, you may set Dynamic DNS (DDNS) to be used for network
access.
Prior registration with your ISP is required before configuring the system to use DDNS.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the DDNS tab to enter the DDNS Settings interface.
3. Check the DDNS checkbox to enable this feature.
4. Select DDNS Type. Five different DDNS types are selectable: IPServer, DynDNS, PeanutHull, NO-IP and HiDDNS.
•
IPServer: Enter Server Address for IPServer.
87
Figure 9.2 PPPoE Settings Interface
Figure 9.3 PPPoE Settings Interface
Figure 9.4 DDNS Settings Interface
POWERED BY